md-textil underbelt loop surface with SNAP-Buckle
The md-textil underbelt with SNAP-Buckle has a width of 38mm and is made of material according to BW-TL or Mil-Spec.
On the outside, the entire belt is covered with VELCRO® Brand Loop® so that an outer belt can be attached.
A FidLock SNAP-Buckle is used as a closure and is mechanically self-closing due to small neodymium magnets. For opening the two buckle parts have to be slided against each other.
The belt has an internal reinforcement, which ensures an optimal mix of comfort and stability.
- G1 80cm-90cm
- G2 85cm-95cm
- G3 90cm-100cm
- G4 95cm-105cm
- G5 100cm-110cm
- G6 105cm-115cm
- G7 110cm-120cm
- > 120 or <80cm as an individual custom made belt.
!! IMPORTANT SIZE NOTE !!
To avoid unnecessary returns and the associated effort, it is essential to observe the following information on size determination.
To get the correct waist size / belt length, proceed as follows:
- Wear trousers that are normally used with a belt on duty / everyday life
- NO belt may be looped into the pants
- Pull the tape measure through the flaps of the trousers
- Read off the waistline
The waist measurement determined in this way, applies to a belt that is worn in trousers. If the belt is going to be used over clothing or in the battle belt, place the measuring tape over the clothing or through the battle belt to determine the size.
To use a combination of upper and lower belt, the lower belt must be ordered according to your actual size, the upper belt must be ordered one number (5cm) larger to compensate the difference in circumference of the lower belt.
Which does absolutely not work:
- Measure the existing belt
- converting the pants size
- reconning, guessing, cartomancy
If you have any questions or uncertainties, get advice by phone -> +49 (0) 7582 675 9825 or by email at email@example.com
All belts we offer are carefully handcrafted in Germany.
We must point out that this belt, despite the high load capacity, is not a belt for personal safety or as a PPE replacement. If you need a belt approved as PPE, please use the models from the MGS (modular belt system) series.
|Product weight:||0,14 Kg|