Jed Belt MGS (Modular Belt System)
The Jed Belt MGS is the basic component of our modular belt system and can be upgraded to a posture belt certified according to EN358, a seat belt EN12277 or a full body harness EN361.
Due to the AustriAlpin D-Ring Cobra and a specially designed seam pattern that can absorb forces from all directions, this belt has a breaking load of> 30kN (> 3059kg).
We have the 43mm wide, double-layered, TYPVII webbing made according to our specifications in Germany and ensure a comfortable fit with maximum resistance for everyday use. VELCRO® Brand Loop® is sewn on the inside of the belt over the entire length to accommodate the adapter for our MGS leg loops or other accessories.
The D-Ring Cobra is simply clicked shut and then locks reliably. The lock can only be opened if there is no load on the Cobra and both lock transmitters are activated at the same time, this guarantees safe handling.
The extra length to adjust the size is cut diagonally for better handling and fixed with a hook-and-loop piece and allows the belt to be adjusted by 10cm in circumference.
The Jed Belt MGS achieves the following certifications:
In combination with our modular belt MGS or comparable: EN358 retaining belt
In combination with our leg straps MGS EN12277 TYP C seat harness (climbing harness)
In combination with our chest harness MGS EN12277 TYPE A complete harness AND EN361 full body harness
Standard sizes:
- G1 80cm-90cm
- G2 85cm-95cm
- G3 90cm-100cm
- G4 95cm-105cm
- G5 100cm-110cm
- G6 105cm-115cm
- G7 110cm-120cm
- > 120 or <80cm as an individual one-off production.
!! IMPORTANT SIZE NOTE !!
In order to avoid unnecessary returns and the associated effort, it is essential to observe the following information on determining the size.
To get the correct waist size / belt length, proceed as follows:
- Wearing trousers that are normally used with a belt on duty / everyday life
- NO belt may be looped into the pants
- Pull the tape measure through the flaps of the trousers
- Read off the waistline
- The waist measurement determined in this way applies to a belt that is worn in trousers.
If the belt is to be used over clothing or in the battlebelt, for example, the measuring tape must be placed over the clothing or through the battlebelt to determine the size.
Which does not work:
- Measure the existing belt
- converting the pants size
- estimating, guessing, cartomancy
If you have any questions or uncertainties, get advice by phone -> +49 (0) 7582 675 9825 or by email at kontakt@md-textil.de
